Home > Bicycle Engine Parts > Aftermarket >

5mm Jets for NT Carburator
No drill front motor mount
 
Alternative Views:


Our Price: $4.99


Product Code: MP775MM


Jet Size*:


 
Description
 
Genuine Dellorto jet. 5mm thread for use on stock NT 2 stroke carburetor to dial in proper fuel air mix. You will need to learn to read your spark plug and learn a bit about tuning prior to changing jets, but it's not too difficult, and changing the jet itself is straight forward. Just drain the fuel, remove the float bowl and unscrew the jet, then reassemble. Sizes range from 0.60 to 0.78 mm, in 0.02 mm increments. Stock size is 0.70 mm..

Fits NT Carburator, Speed Carb and SHA Clone Carburator

Average Customer Review: Average Customer Review: 4.5 of 5 4.5 of 5 Total Reviews: 2 Write a review.

  0 of 0 people found the following review helpful:
 
5 of 5 Tuning with jets July 19, 2014
Reviewer: Anthony Andrews from Bethel, ME United States  
Just bought two of each size to try and dial in my bikes.
I don't see how you would get your bike to run it's best without playing with the jets.
It's really not that hard to change and monitor the burn. totally worth the money.

Was this review helpful to you?

  1 of 1 people found the following review helpful:
 
4 of 5 sizes 72,74, and 68 August 13, 2012
Reviewer: Anonymous Person from bradenton, FL United States  
i ended up using the smaller jet 68 it works, but at first it worried me cause the threads are not perfect and do not fit like the stock jet. the new jet does not screw all the way in flush very tight fit. to the point where i felt like it would strip the carb out if i screwed it in flush like the stock jet. but they do work good. only reason i knocked down to 4 stars was the fitment.

Was this review helpful to you?


Browse for more products in the same category as this item:

Bicycle Engine Parts > Aftermarket
Bicycle Engine Parts > Carburetor and Fuel
Bicycle Engine Parts